hydrocarbons · Alberta

Hydrocarbon and contaminated soil remediation in Alberta

Nelson supports contaminated soil treatment and hydrocarbon remediation in Alberta, drawing on 30+ years of hydrocarbon project experience. Petroleum- and diesel-impacted soil, site conditions and applicable cleanup objectives are reviewed together to define the appropriate remediation approach.

This page brings together Alberta regulatory context, mobile thermal treatment planning and the documentation needed to support the project team. Each site requires its own assessment and approvals.

Thermal remediation services

Contaminated soil treatment in Alberta

Contaminated soil treatment in Alberta begins with characterization of the affected ground and the intended cleanup objectives. Existing assessments, laboratory results, estimated soil quantities and land-use requirements help establish which material streams need management and which methods are technically suitable.

Nelson offers soil treatment and disposal pathways. Excavation, segregation, mobile thermal treatment, approved offsite disposal and reuse may be parts of the same project. Decisions are made for each soil stream, with receiving conditions, treatment suitability and all required approvals considered together.

Alberta's oil and gas legacy sites and industrial properties require a clear distinction between contamination assessment, oilfield waste management and land restoration. Start with the governing site framework and actual material profile rather than assume that every excavation has the same handling requirements.

Petroleum and diesel contaminated soil remediation

Petroleum releases can leave gasoline, diesel, crude oil and weathered hydrocarbon fractions in soil. Site history and analytical results establish which hydrocarbon fractions, BTEX, PAHs and other contaminants need attention. Free product and affected groundwater may need separate measures alongside soil remediation.

For suitable excavated soil, thermal desorption separates organic contaminants from the soil matrix. The configured off-gas train then destroys or recovers the separated organics. Moisture, soil texture, organic loading and cleanup criteria influence feed preparation and equipment selection. Co-contaminants and residual streams must also be assessed.

Petroleum hydrocarbons: contaminants and treatment

Contaminated soil treatment with thermal desorption

Alberta Tier 1 and Tier 2 soil remediation requirements

Alberta Tier 1 provides generic soil and groundwater remediation guidelines for defined land uses and exposure pathways. Tier 2 provides a framework for modifying the applicable guidelines using site-specific information. The project professional must confirm the current editions, applicable pathways and objectives for the site.[3][4]

Upstream oilfield waste management is also subject to applicable AER requirements, including Directive 058. It does not establish a universal requirement to thermally destroy every hydrocarbon-impacted soil stream. Waste management, remediation and reclamation certification involve distinct requirements; treatment results alone do not establish that all closure obligations have been met.[1][2]

Alberta Tier 1 and Tier 2: assessment, treatment and verification

Alberta oilfield waste, remediation and reclamation

Waste classification and management under applicable AER requirements, contaminated-site remediation against defined objectives, and reclamation of the land are distinct parts of a project. Directive 058 applies within its oilfield waste scope; it is not a blanket rule requiring thermal treatment of every impacted soil stream.[1]

Identify who is responsible for assessment, waste handling, confirmation sampling, land restoration and any certificate application. A treated-soil laboratory result does not by itself complete reclamation or establish full regulatory closure.[2]

Legacy Alberta wellsite treatment experience

Mobile thermal desorption from Acheson

Nelson's headquarters and equipment staging are in Acheson, west of Edmonton. The RS-series mobile thermal fleet supports site-specific deployment planning across Alberta, including industrial properties and legacy wellsites. Access, available working area, utilities, material preparation and project approvals are reviewed before selecting a configuration.

Mobile thermal fleet configurations and design envelopes

How thermal desorption works

Alberta remediation project experience

The Bear Hills project documents hydrocarbon-contaminated soil treatment on Louis Bull First Nation land in Alberta. Nelson’s Alberta wellsite project record also describes thermal treatment of legacy drilling waste and impacted soil. These records demonstrate actual applications; their conditions and outcomes are not guarantees for a different site.

Bear Hills project record

Alberta wellsite remediation project record

Alberta Tier 1 and Tier 2 remediation guide

Preparing an Alberta remediation scope

Provide the intended land use, analytical results linked to locations and depths, soil texture, groundwater observations and estimated quantities. Ask your environmental professional to identify the applicable guideline edition and relevant Tier 1 or Tier 2 objectives before comparing treatment proposals.[3][4]

Acheson staging supports Alberta deployment planning, but remote wellsite access and constrained industrial properties need different layouts. Identify stockpile areas, utility limitations, seasonal conditions and sensitive receptors so material preparation and equipment selection fit the actual site.

Prepare a site-specific remediation inquiry

Soil treatment verification and project documentation

Agree on sampling, analytical methods, stockpile segregation and reporting requirements before treatment. Confirmation results establish whether the sampled material meets the project criteria. Treatment records, emissions documentation where applicable, and traceable material movements support the final project record.

Any disposal destination must be authorized or eligible to receive the actual material. Treated soil reuse also requires confirmation of the applicable conditions. Regulatory completion is assessed within the governing framework; neither treatment nor receiving receipts alone establish that all site obligations are complete.

Contaminated soil disposal planning checklist

Discuss your remediation project

hydrocarbons · Alberta

Scope a hydrocarbon project in Alberta.

Send the matrix, approximate volume, location, and cleanup criteria. Nelson will identify the treatment route, evidence requirements, and practical next step.

Thermal remediation services

1.888.960.8222

Planning your Alberta soil remediation project

Provide the site location, environmental assessments, laboratory results, approximate soil quantity, intended land use and access constraints. These inputs support a site-specific review of treatment configuration, disposal requirements and verification responsibilities.

Frequently asked

Can Nelson treat petroleum- and diesel-contaminated soil in Alberta?
Nelson’s mobile thermal systems treat suitable hydrocarbon-impacted soil. Suitability depends on the contaminant profile, soil properties, feed preparation, project criteria and required approvals. A site-specific review establishes the proposed configuration.
Can treatment and disposal be used on the same project?
Yes. Different soil streams can require different management routes. Treatment, approved disposal and eligible reuse are considered according to characterization, receiving conditions and the project objectives.
Does treatment verification automatically establish regulatory closure?
No. Confirmatory testing documents treatment results against defined criteria. Site closure, certification or other regulatory completion requires the applicable assessment, documentation and regulatory process.
What should I send Nelson for a project discussion?
Send the site location, available assessments and laboratory data, estimated soil quantity, intended land use and practical access constraints. Identify known co-contaminants and any applicable approvals or orders.

Discuss your Alberta remediation project

Share the site location, assessments, contaminant profile and approximate soil quantity. Nelson can review the treatment and material-management requirements with your project team.

Toll-free 1.888.320.9714

Canada HQ 1.780.960.3660

Qualified enquiry

Tell us about your site in Alberta

Send the contaminant profile, approximate tonnage, and site location. Nelson will respond with the route that fits and the evidence needed to verify it.

hydrocarbons · Other regions

British Columbia

Saskatchewan

Manitoba

Northwest Territories

Ontario

Quebec

New Brunswick & Atlantic Canada

Canada

United States

Texas

North Dakota

Pennsylvania

California

Alaska

Washington State

Treatment approach · By contaminant

Petroleum HydrocarbonsThe full spectrum of petroleum-derived organic compounds — crude oil, condensate, diesel, gasoline, jet fuel, and bunker fuel — reported analytically as total petroleum hydrocarbons (TPH) in gasoline-range (C6–C10), diesel-range (C10–C28), and heavy-range (C28–C40) fractions.

BTEX (Benzene, Toluene, Ethylbenzene, Xylenes)The four aromatic hydrocarbon compounds — benzene, toluene, ethylbenzene, and the three xylene isomers — that dominate gasoline plumes and drive risk-based cleanup at UST and refinery sites because of benzene's carcinogenicity and low regulatory threshold.

DNAPL and LNAPL (Non-Aqueous Phase Liquids)Free-phase organic liquids that do not fully dissolve in water and act as long-term source zones for dissolved plumes — DNAPL (denser than water: TCE, PCE, creosote, coal tar) pools below the water table; LNAPL (lighter than water: gasoline, diesel, jet fuel) floats on it.

Chlorinated VOCs (CVOCs)Chlorinated volatile organic compounds: a family of chlorinated solvents including TCE, PCE, vinyl chloride, and DCE that migrate readily in soil vapor and groundwater and require chemical, biological, or thermal treatment.

Chlorinated Solvents (TCE, PCE, TCA, DCE, VC)Man-made chlorinated aliphatic hydrocarbons — tetrachloroethylene (PCE), trichloroethylene (TCE), 1,1,1-trichloroethane (TCA), cis-1,2-DCE, and vinyl chloride — that formed the industrial degreasing and dry-cleaning solvent market for four decades and left the densest DNAPL groundwater plumes in North America.

In-Situ Chemical Oxidation (ISCO)In-situ chemical oxidation: injection of a chemical oxidant — permanganate, persulfate, or Fenton's reagent — directly into contaminated soil or groundwater to destroy dissolved-phase organic contaminants without excavation.

Regulator sources

[1]AER Directive 058: Oilfield Waste Management Requirements

[2]Alberta Conservation and Reclamation Regulation

[3]Alberta Tier 1 Soil and Groundwater Remediation Guidelines

[4]Alberta Tier 2 Soil and Groundwater Remediation Guidelines

All Capabilities

Environmental remediation services in Canada and the United States

Hydrocarbon remediation services: 30+ years of treatment experience

More from Nelson

  • PFAS and the changing landscape: What site owners should know
  • LNAPL remediation regulations: How to identify the requirements for your site
  • Alberta Tier 1 soil and groundwater remediation guidelines: How to assess their applicability
  • Mobile thermal technology: configured for the material, brought to site
  • How to use The Hub for contamination research
  • Navigator: a practical guide to remediation strategy
  • The Ground Truth: Warren Nelson's remediation newsletter
  • A new era of enlightenment
  • Value should be the final outcome
  • What’s next at Nelson
  • Why independent research matters more than anything
  • Over thirty years of permanent outcomes: a field review of Nelson’s project record

Site Navigation

  • All Articles & Research
  • Thermal Remediation Capabilities
  • Project Case Studies
  • Remediation Glossary
  • About Nelson Environmental Remediation
  • Contact Nelson